Table of Contents
Advertisement
19
Key Switch
KEY SWITCH
See General Warnings on page 1-2.
TESTING THE KEY SWITCH
See Test Procedure 5 – Key Switch (Start Circuit) on page 18-24.
See Test Procedure 6 – Key Switch (Engine Kill Circuit) on page 18-24.
KEY SWITCH REMOVAL
1.
Disconnect battery and spark plug wire(s). See Side-Post Battery: Disconnecting the Battery-Gasoline
Vehicles on page 1-3.
See Top-Post Battery: Disconnecting the Battery- Gasoline Vehicles on page 1-4.
2.
Remove the instrument panel.
2.1.
Remove three screws (1) from the instrument panel (2) (Figure 19-21, Page 19-20).
2.2.
Rotate the instrument panel up and away from the dash to disengage the tabs at the top of the instrument
panel.
2.3.
Disconnect the electrical connector (3) to the instrument panel.
2433
Figure 19-21 Instrument Panel Removal
3.
Disconnect the wires from the key switch.
4.
From the back of the instrument panel, push down on the retaining tabs surrounding the key switch (4) and
remove the key switch cap (8). Hold the key switch and remove the switch retaining nut (6) from the outside of
the instrument panel (Figure 19-22, Page 19-20).
Page 19-20
2016 Precedent Golf Car Maintenance and Service Manual
1
3
1
ELECTRICAL COMPONENTS – SUBARU EX40
9
703
Figure 19-22 Key Switch
8
6
Advertisement
Table of Contents
Troubleshooting
