Transaxle Installation - Club Car Precedent 2016 Maintenance And Service Manual

24

Transaxle Installation

1
1
3063
Figure 24-13 Transaxle Mounting Bolts
TRANSAXLE INSTALLATION
See General Warnings on page 1-2.
1. Installation is reverse of removal procedure. When attaching transaxle to powertrain, initially install the eight bolts
(1) finger-tight (Figure 24-13, Page 24-12). Then, tighten fasteners in the following order:
1.1. Tighten the two bolts (1) at clutch plate (3) to 50 ft·lb (68 N·m).
1.2. Tighten the four bolts (1) at engine pan (2) to 50 ft·lb (68 N·m).
1.3. Tighten the two bolts (1) at muffler bracket to 50 ft·lb (68 N·m).
1.4. Tighten the governor cable bracket (2) and FNR/accelerator cable bracket (2) bolts to 50 ft·lb (68 N·m)
(Figure 24-6, Page 24-9).
1.5. Tighten leaf spring hardware to 19 ft·lb (26 N·m) at chassis and shackle. See Rear Suspension section.
1.6. Tighten lower nuts of shock absorbers until cushions expand to be the same diameter as the mounting
washers.
1.7. Tighten transaxle drain plug to 17 ft·lb (23.5 N·m).
2. Fill transaxle with appropriate type and volume of oil. See Oil Change – Transaxle on page 24-2.
3. Ensure that all wires and cables are secured properly with wire ties. See following WARNING.
WARNING
• If wires and cables are removed or replaced make sure they are properly routed and secured to vehicle
frame. Failure to properly route and secure wires and cables could result in vehicle malfunction,
property damage or personal injury.
4. Connect battery and spark plug wire(s). See Side-Post Battery: Connecting the Battery-Gasoline Vehicles
on page 1-3.
See Top-Post Battery: Connecting the Battery- Gasoline Vehicles on page 1-4.
5. Check governor adjustment and correct if necessary. See Governor Cable Installation and Adjustment,
Section 21, Page 21-7.
6. Check engine RPM setting. Adjust if necessary. See Engine RPM Adjustment, Section 21, Page 21-11.
Page 24-12 2016 Precedent Golf Car Maintenance and Service Manual
3
2
TRANSAXLE, FUJI ED65 (FOR SUBARU EX40)