Club Car Precedent 2016 Maintenance And Service Manual page 291

TROUBLESHOOTING AND ELECTRICAL
SYSTEM – SUBARU EX40
TEST PROCEDURE 2 – Fuses
See General Warnings on page 1-2.
WARNING
• Failure to use properly rated fuse can result in a fire hazard.
NOTE: This vehicle uses three ATM-style blade fuses. A single ABC-style glass fuse is used for the Guardian/Visage
4-pin connector that is labeled "V3 circuit" on the harness.
This is a voltage test. It can be performed relatively easily on ATM-style fuses. A voltage test can be
performed on the ABC-style glass fuse if insulation-piercing probes are used. Otherwise, the ABC-style will
have to be removed to visually inspect or check using a continuity test.
ATM-style blade fuses are located on the main wire harness in front of the battery.
The ABC-style glass fuse is located on the main wire harness adjacent to the ATM-fuse holder.
2784
Figure 18-8 Testing ATM-style Blade Fuse
1. If necessary, see Testing Basics on page 18-14.
2. Access the fuse but do not remove it.
3. 20-amp and 10-amp ATM Fuses Only: With the battery and solenoid connected:
3.1. Probe the two, small metal contacts on the top of the fuse (Figure 18-8, Page 18-19).
3.2. Each contact should show battery voltage.
3.3. If only one side shows battery voltage, replace fuse.
3.4. If neither side of a fuse shows battery voltage, inspect the following locations:
– Check condition and connection of large red wires at solenoid.
– Check sonic weld_8 in main wire harness.
15
2016 Precedent Golf Car Maintenance and Service Manual
18
Test Procedures
Page 18-19