Club Car Precedent 2016 Maintenance And Service Manual page 235

BATTERY CHARGER: FOR ERIC CHARGING
15
SYSTEM Test Procedures
TEST PROCEDURE 7 – Charger Output Test
Without a Meter: Connect DC cord and start a charge cycle. If buzzer sounds three times, then charger is functioning.
Both a confirmed connection with the charger and a rise in battery pack voltage are required for buzzer to sound
three times. See following NOTE.
NOTE: The number of flashes and beeps can vary depending on the Beep Option setting. See Beep Option,
Section 11, Page 11-8.
With a Meter: A clamp meter can be used to measure current in the red battery cable (connected to the positive (+)
post of battery no. 1) while charging. Current can reach just over 13-amps at the beginning of a charge session
and taper down to approximately 5-amps near the end.
2016 Precedent Golf Car Maintenance and Service Manual Page 15-19