Headlight Adjustment; Aiming The Headlight Beam - Club Car Precedent 2016 Maintenance And Service Manual

4

Headlight Adjustment

HEADLIGHT ADJUSTMENT
Headlights are available as an accessory on this vehicle. To raise or lower the headlight beam, washers can be added
to the mounting hardware between the headlight and the bumper assembly.
See General Warnings on page 1-2.

AIMING THE HEADLIGHT BEAM

1. Park the vehicle on a level surface 5 feet away from, and facing a vertical surface such as a garage door or wall.
2. On the vertical surface, mark a 24 inch (61 cm) long, horizontal line 15-1/2 inches (39.4 cm) above the ground
directly in front of the vehicle.
3. Turn on headlight. Take note where the beam strikes the vertical surface in relation to the marked horizontal
line. To raise the beam, add washers (size M6) to the lower mounting screw (1). To lower the beam, add
washers to both upper screws. Tighten screws to 66 in·lb (7.5 N·m). While it is possible to add washers with
the headlight/bumper assembly mounted to the vehicle, these adjustments may be easier if the headlight/front
bumper assembly is unbolted first (Figure 4-3, Page 4-6).
715
Page 4-6 2016 Precedent Golf Car Maintenance and Service Manual
3
Figure 4-3 Headlight Aiming
BODY AND TRIM
1
2