Installation - BOMBARDIER Johnson 90 Service Manual

POWER TRIM AND TILT - 140
INSTALLATION
INSTALLATION
lnstallation is reverse order of removal with special attention
to the following steps.
Lower tilt rod to full down position.
Apply Triple Guard Grease to the tilt cylinder lower shaft and
lower shaft bushes.
lnstall bushes
G)
and cylinder lower shaft
(í)
to PTT unit.
~ Triple Guard Grease
Place the PTT unit in position, then install the clamp bracket.
Tighten the clamp bracket shaft nut to specified torque.
~ Clamp bracket shaft nut: 43 N,m
(4.3 kg-m, 31.0 lb-ft)
Tighten lower shaft bolts @, pre-coated with thread lock, to
specified torque.
tf&
500421: Nut Lock
~ Cylinder lower shaft bolt: 50 N,m
(5.0 kg-m; 36.0 lb-ft)
lnstall anode @, then tighten bolts securely.
8-43