Disassembly - BOMBARDIER Johnson 90 Service Manual

POWER TRIM
ANO TILT - 90/115
PTTMOTOR
Disassembly
1. For correct assembly, scribe an alignment mark on field
case and brush holder.
2. Remove tape from PTT motor cables and cable protector
tube, then slide cable protector tube upward.
3. Remove screw securing motor cable holder
<D,
then slide
motor cable holder and grommets
®
out as shown in fig­
ure.
4. Remove two screws @ securing field case to brush
holder.
5. Slide field case upward and away from brush holder.
NOTE:
When separating field case from brush holder, proceed by
pushing PTT motor cables into brush holder side.
6. Disconnect PTT motor cables from brush holder.
7. Remove armature from field case. Note position of O-ring
encircling brush holder.
8-18