Assembly; Tilt Rod And Piston - BOMBARDIER Johnson 90 Service Manual

POWER TRIM AND TILT-140
ASSEMBLY
ASSEMBLY
Assembly is reverse order of disassembly with special atten­
tion to following steps.
IACAUTION
1
• Do not reuse O-rings after removal, always use new O­
rings.
• Lubricate all components and O-rings with PTT fluid
before assembly.
• Do not reuse PTT fluid, always refill with new fluid.
Tilt Rod and Piston
When tightening the piston retaining nut on the tilt rod pisten,
apply Nut Lock to the threads.
Tlqhtsn the nut to specified torque.
~ 500421: Nut Lock
~ Piston retaining nut: 100 N-m (10 kg-m; 72 lb-ft)
lnstalling tilt rod/piston
Pour 100 mi of PTT fluid into cylinder.
lnsert the free- pisten into cylinder and push it down to the
bottom of the cylinder.
Pour PTT fluid into the cylinder until it is topped off.
lnsert the tilt rod/piston into cylinder and thread the tilt cylin­
der head by hand until fully seated.
Tighten the cylinder head to specified torque using special
tool.
~ Tilt cylinder head: 160 N-m (16 kg-m; 115.7 lb-ft)
1- M ot¡
326485: PTT cylinder cap tool
Free pistan
yliode~
Top OFF
8-37