Intake Manifold Assembly; Removal - BOMBARDIER Johnson 90 Service Manual

POWER UNIT
INTAKE MANIFOLD ASSEMBLY
INTAKE MANIFOLD ASSEMBLY
Removal
Before removing intake manifold:
• Relieve fuel pressure. (See page 5-3)
• Disconnect battery cables from battery.
• Remove both side covers. (See page 7-2)
1. Remove flywheel cover.
2. Remove two bolts and air duct
G).
3. Remove evaporation hose
(í)
from cylinder head cover.
4. Disconnect fuel outlet hose
®
and fuel inlet hose
@
from
low pressure fuel pump.
5. Loosen clamp and place a large cloth over end of fuel
feed hose @. Slowly pull fuel feed hose from fuel delivery
pipe
1
§). Drain any excess fuel in hose into a small con­
tainer.
6. Disconnect tour fuel injector connectors
( ! ).
7. Disconnect high pressure fuel pump connector
@
from
fuel vapor separator.
6-2