Electric Parts Holder; Removal - BOMBARDIER Johnson 90 Service Manual

ELECTRICAL
ELECTRIC PARTS HOLDER
ELECTRIC PARTS HOLDER
Removal
Before removing electric parts holder:
• Disconnect battery cables from battery.
• Remove PORT side cover.
1 . Remove electric parts holder cover.
2. Remove three bolts and silencer case
G).
3. Disconnect lead wire connector from ECM, then remove
ECM.
4. Disconnect following lead wire in electric parts holder.
• Connector of rectifier and regulator (W).
• Connector of CKP sensor.
• Connector of exhaust manifold sensor.
• Connector of ECM main relay.
• Connector of starter relay.
• Red lead wire on 60A main fuse upside terminal.
• White 30A fuse lead and white rectifier and regulator lead
wire on 60A main fuse lower side terminal.
• Pink and light blue lead wires of PTT motor relay.
• Blue lead wire on PTT motor relay terminal.
• Green lead wire on PTT motor relay terminal.
• Red lead wire on Up PTT motor relay terminal.
5. Remove bolt securing starter motor band, then remove
negative battery cable and main harness GND lead.
6. Disconnect Red lead wire from terminal "S" on starter
motor.
7. Pull out 30A fuse case from electric parts holder.
8. Remove bolt, GND lead wire and electric parts holder.
NOTE:
To remove electric parts holder, first, slide bottom side of
electric parts holder to the left, then slide parts holder toward
direction of ten (10) o'clock.
lnstallation
lnstallation is reverse order of removal. See page 10-2 to 10-
7 for check of wire routing.
4-23