Oil Pressure Switch - BOMBARDIER Johnson 90 Service Manual

ENGINE CONTROL SYSTEM
FLYWHEEL
Oil Pressure Switch
REMOVAL
1. Remove bolts and air duct G).
2. Loosen bolt and disconnect blue lead wire from switch.
3. Remove oil pressure switch from cylinder block.
INSTALLATION
lnstallation is reverse order of removal with special attention
to the following steps.
• Before installing oil pressure switch, wrap screw threads
with sealing tape then tighten switch to specified torque.
NOTE:
Cut off any excess sealing tape from switch threads before
installation.
~ Oil pressure switch: 13 N,m (1.3 kg-m; 9.5 lb-ft)
• Start engine and check oil pressure switch for oil leakage.
Reseal switch if oil leakage is found.
1. Sealing tape
3-51