Disassembly - BOMBARDIER Johnson 90 Service Manual

ELECTRICAL
STARTER MOTOR
Disassembly
For overhauling of starting motor, it is recommended that
component parts should be cleaned thoroughly. However,
yoke assembly, armature coil, overrunning clutch assembly,
magnetic switch assembly, rubber or plastic parts should not
be washed in degreasing tank or with grease dissolving sol­
vent. Those parts should be cleaned with compressed air
and wiping with cloth.
NOTE:
Before disassembling starting motor, be sure to put match
marks at three locations (A, B and C) as shown in right figure
so that any possible component alignment mistakes can be
avoided.
1. Remove nut
G)
from magnetic switch, then disconnect
connecting wire
(2).
2. Remove two bolts
@
securing magnetic switch.
3. Remove magnetic switch @ and rubber packing @.
4. Remove screws @, long through bolts
(! )
and rear cover
@.
4-13