Oil Level Ano Bleeoing; Oil Level; Air Bleeding - BOMBARDIER Johnson 90 Service Manual

POWER TRIM ANO TILT-140
OIL LEVEL ANO BLEEDING
OIL LEVEL ANO BLEEDING
Oil Level
To check the oil level:
1. Raise the engine to a full-tilt position.
2. Lower the manual tilt lock lever
G).
3. Remove the oil filler plug ~-
4. lf oil can be seen at filler plug level, the unit is full.
5. lf oil level is low, refill with the recommended oil.
Recommended oil:
Dexron automatic transmission fluid or equivalent
j~CAUTION
i
To ensure consistent pump operation, do not mix differ­
ent types of oil.
6. Reinstall oil filler plug.
Air Bleeding
1. Check that the manual release valve is tightened to the
specified torque.
~ Manual release valve: 3.5 N-m (0.36 kg-m; 2.6 lb-ft)
i~CAUTION
i
Do not over-tighten manual release valve.
Counterclockwise
=
open
Clockwise
=
close
2. Operate the PTT switch, raising and lowering the motor
up and down (full tilt position to full trim down position) 4
to 5 times.
3. Check oil level, topping off if necessary.
4. Reinstall oil filler plug.
Oil level (when full-tilted position)
®
Manual ralease valva
8-31