Pttmotor; Removal - BOMBARDIER Johnson 90 Service Manual

POWER TRIM AND TILT-90/115
PTT MOTOR
PTT Motor
See "lnstallation" on page 8-22.
• Pour recommended PTT fluid in to reservoir until specified
level.
• Perform air bleeding procedure. See "Air Bleeding" on
page 8-10.
PTTMOTOR
Removal
NOTE:
Before removing PTT motor, wash the PTT body with a stiff
bristle brush and hot, soapy water to remove sand or dirt and
dry PTT body with compressed air.
1. Place lower mounting eye of PTT cylinder in a vise.
Tighten vise only enough to secure PTT unít, do not over
tighten.
NOTE:
To prevent damage to PTT cylinder use wood blocks, vise
jaw protectors, etc., between vise jaws and PTT components
before tightening vise.
2. Remove tour bolts securing PTT motor to PTT pump
case.
3. Detach PTT motor from PTT pump case. Note position of
drive joint
G)
and O-ring ~ and remove them.
8-17