Replacing The Pilot Valve Manifold; Reinstalling The Electronic Module - Ametek 3050-AMS User Manual

Replacing the Pilot Valve Manifold

1. Position the Pilot Valve Manifold on the Electronics Module mounting
2. Attach the tubing you identified and removed earlier. Make sure that you
3. Secure the Pilot Valve Manifold to the sample manifold plate using the

Reinstalling the Electronic Module

Once you have serviced the various components in the Electronics Module,
reassemble the analyzer.
1. Carefully reposition the Electronics Module above and to the front of the
2. Attach the mounting plate of the Electronics Module to the analyzer as-
Receptacle Plug
Figure 4-12.
3050-AM Module
reinstallation.
PN 305804902, Rev A
plate. Attach with the four (4) screws you removed earlier.
are attaching the correct tubing to each valve.
Philips-head captured screws.
analyzer. Lower the module into the analyzer so the screws at the four
corners can be attached.
sembly using the four (4) captured screws you removed earlier.
Use Philips
screwdriver
Screws (large)
Receptacle Plug
Spring Loaded
Captured Screws
Maintenance and Troubleshooting | 4-19
Use slotted
screwdriver
Screws (small)