Table of Contents
Advertisement
Capillary
The capillary (Figure 4-4) is a part of the flow meter in the analyzer and can
easily be replaced when necessary.
Removing the Capillary
1. Remove the top cover from the analyzer and remove the cover from the
2. Disconnect the capillary and remove it by loosening both nuts and gently
Installing the Capillary
1. To install the capillary, gently push the tubing ferrules on the capillary into
2. Replace the Oven cover and secure it with the two (2) nuts. Replace the
Figure 4-4.
Capillary location – 3050-AMS.
PN 305804902, Rev A
Sample Oven. Facing the front of the 3050-AMS Analyzer, the capillary is
found on top of the stream switching manifold (Figure 4-4).
pulling the tubing out of the stream switching manifold block.
the tubing on the manifold block until flush and tighten the nuts to secure.
analyzer cover and secure it with the mounting screws.
Capillary
Proportinal
Solenoid
Valve
Manifold
Maintenance and Troubleshooting | 4-7
Proportinal
Solenoid
Valve
Sensor
Advertisement
Table of Contents
