CyberData 011324 Series Operation Manual page 43

2. On the Audio page, you may enter values for the parameters indicated in
Note
Web Page Item
Volume Settings (0-9)
Enable Line-in to Line-out Loopback
SIP Volume
Multicast Volume
Ring Volume
Sensor Volume
Volume Boost:
No Volume Boost
Volume Boost 1
Volume Boost 2
Volume Boost 3
Operations Guide
The question mark icon (
after the Toggle Help button is pressed
Table 2-11. Audio Page Parameters
Description
Line-in audio will play back out the device's audio output ports. This is the
lowest priority audio and will be preempted by any other audio stream.
Set the speaker volume for a SIP call. A value of 0 will mute the speaker
during SIP calls.
Set the speaker volume for multicast audio streams. A value of 0 will mute
the speaker during multicasts.
Set the ring volume for the Nightringer. A value of 0 will mute the speaker
for the Nightringer.
Set the speaker volume for playing sensor activated audio. A value of 0
will mute the speaker during sensor activated audio.
NOT RECOMMENDED! Set the Boost level to increase the volume
output of the speaker. Using Volume Boost may introduce audio clipping,
reduce intelligibility of the speaker audio, or cause instability. Boost will
raise the volume above level '9', regardless of the digital volumesettings.
If Boost is going to be used, it should be usedwith low gain audio sources
and at a low volume output level.
Click the Save button to save your configuration settings.
Click on the Reboot button to reboot the system.
Click on the Toggle Help button to see a short description of some of the
web page items. First click on the Toggle Help button, and you will see a
question mark (
mouse pointer to hover over a question mark to see a short description of
a specific web page item.
Click on the Test Audio button to do an audio test. When the Test Audio
button is pressed, you will hear a voice message for testing the device
audio quality and volume.
931971A
) in the following table shows which web page items will be defined
.
) appear next to some of the web page items. Move the
Installing the SIP Paging Amplifier
SIP Paging Amplifier Setup
Table 2-11.
CyberData Corporation
36