Board Options - Quantum E240 User Manual

BOARD OPTIONS

9
Warning: Changing components on the board involves soldering and unsoldering; please take
care not to overheat the board or to leave excessive flux which can affect signal stability
and performance. If in doubt, clean the board with a commercial flux remover and dry it prior to
use.
Figure 5 — Jumper Positions Showing Default Configuration
The E240 as shipped is factory configured to operate in fast mode with spread spectrum
enabled, and with a 10-second recalibration delay. The user can re-configure the jumpers to
change these settings using zero-ohm 0603 SMD resistors or bits of fine wire.
See next page for available jumper combinations.
Downloaded from Elcodis.com electronic components distributor