Table of Contents
Advertisement
DAT 320 Quick Start Guide
Installing the Tabletop DAT 320 Tape Drive to Your System
Connecting the Power
and USB Cables to Your
Tabletop Drive
Figure 7 Connecting Power
and USB Cables
Completing Your
Installation
10
Installing the tabletop DAT 320 tape drive consists of the following major steps:
•
Connecting the Power and USB Cables to Your Tabletop Drive
•
Completing Your Installation
Note: The drive is not powered from the USB bus. It must be connected to the main
power supply.
A power cable is provided with your Quantum DAT 320 tape drive.
1 Make sure that the drive is switched OFF (O side down). The power switch is on the
rear panel.
2 Connect the USB cable to the USB connector on the back of the enclosure.
3 Plug the power cable securely into the socket on the rear panel of the drive and plug
the other end of the power cable into the power outlet.
On/off switch
Power cable
4 Plug the USB cable into the USB connector on the server.
Note: It is important to ensure that you connect your drive to a USB 2.0 port. The
drive will work on a USB 1.1 port but performance will be severely degraded.
To complete and test your tabletop tape drive installation:
1 Use the On/Off Switch on the back of the tabletop tape drive to turn on the drive
(see
Figure
7). The Ready LED should be
be
.
OFF
USB cable
, the other three front-panel LEDs should
ON
Installing the Tabletop DAT 320 Tape Drive to Your System
Advertisement
Table of Contents
Need help?
Do you have a question about the DAT 320 CD320UE and is the answer not in the manual?
Questions and answers