Table of Contents
Advertisement
ATL P1000 Series Library Unpacking Instructions
Document 6221100-02, Ver. 2, Rel. 0
March 1999
Removing a
Rack-mount Library
from the Pallet
24
Procedure (continued)
Roll the library to the installation site.
7
Save the shipping carton, bag, foam supports, ramp, and pallet for
8
future use.
These items are required to package the library for reshipment.
To remove a rack-mount library from the pallet:
Note: The instructions in this section assume you have already installed the
15
slide assembly in the rack. If you have not, do so now, following the
instructions in "Installing the Slide Assembly in the Rack" on page 13.
Procedure
Remove the plastic bag enclosing the library:
1
Cut along the front seam of the plastic bag.
a
Continue to cut all the way to the back of the library.
b
Fold the bag out of the way.
c
Pull the slide tray forward in the rack so it is fully extended.
2
Warning: The rack may tip forward when you extend the slide tray or
place the library on the slide tray. If rack stabilizing feet are
present, extend them during this procedure. If the rack
does not have stabilizing feet, use extreme caution when
extending the slide tray and mounting the P1000 in the
rack.
Removing the Library from the Pallet
Advertisement
Table of Contents
