Fibre Channel Configuration - Quantum Scalar 218FC User Manual

X) Return to previous menu:
The Baud Rate Configuration Menu displays a list of possible baud rates accepted by the Scalar 218FC fibre
channel interface. The default baud rate is 9600.
To select a different baud rate than the default:
1. Press the number corresponding to the desired baud rate in the listing.
To abort baud rate configuration, press X to return to the Scalar 218FC Fibre Channel Configuration Menu.
Alphabetical menu and list choices in the Configuration Program
not
are case sensitive. Uppercase and lowercase characters may
be used interchangeably.
2. Press X on the Baud Rate Configuration menu to return to the Configuration Menu.
3. Press A on the Configuration Menu to save the new baud rate setting.

Fibre Channel Configuration

Each Fibre Channel node is assigned a unique world wide name based on a unique vendor identifier that is
registered with IEEE. The World Wide Name is a 64 bit value. This value is broken into a 32-bit high-order
word and a 32-bit low-order word for configuration. An ADIC World Wide Name has the following format:
High-order 10
Low-order 02
To perform fibre channel configuration, press 2 in the Configuration Menu. This displays the following
menu of choices:
Fibre Channel Configuration Menu
Build Level: a9802
Current Fibre Channel Configuration:
World Wide Name High: 0x10000011
World Wide Name Low: 0x10000001
Use Hard ALPA: No
1) Change World Wide Name High
2) Change World Wide Name Low
3) Toggle Hard ALPA Usage
X) Return to previous menu
This menu displays:
The current value of the high-order word of the Fibre Channel World Wide Name
The current value of the low-order word of the Fibre Channel World Wide Name
The current value of the Hard Source ID (Use Hard ALPA) flag
You can change any of these three values.
Note
00 00 E0
xx xx xx
Configuring the Fibre Channel Subsystem 23