Buzzer Configuration - Quantum Scalar 218FC User Manual

Buzzer Configuration

Enables/disables the sounding of an alarm when an error message or warning alarm is displayed.
Enables/disables the beep sound when you press a keypad key.
To enable the error alarm use the LEFT key to select the ErrAlarm field. Use UP or DOWN to
select "Y" to enable alarm or "N" to disable alarm. When the error alarm is enabled, a continuous
alarm tone will sound in the event of an error message. The alarm will sound until the condition
that caused the error has been removed or any key is pressed. To clear an error message from the
display, press ALT and ENTER.
If you wish to change the status of the keyboard beep, use the RIGHT key to select the Kybd field.
Use UP or DOWN to select "Y" to enable a beep when you press a key or "N" to disable the beep.
BUZZER CONFIGURATION default: Err Alarm: N, Kybd: Y
Press ENTER to make the changes effective or press ESC to return to previous menu item.
Set SCSI ID
Lets you select the SCSI ID for the robotics on the library.
Use UP and DOWN to select the desired ID. Press ENTER to execute the change. Confirm the
change by pressing ENTER again.
SET SCSI ID default is Library's SCSI ID:1.
Note
Note
Equipment Description 49