Rebooting The Scalar 218Fc; Installing The Backup Software - Quantum Scalar 218FC User Manual

7. Click on Send. The downloading process will proceed and the Scalar 218FC will reboot. The following
output is an example that may be different on your system.
.text: 0xa00d0000
.data: 0xa00d0688
.bss: 0xa011f170
Should the download fail, you will see the following message:
Download failed
ERROR:
Downloading of firmware image failed!
Press Any Key to Continue...

Rebooting the Scalar 218FC

For configuration changes to take effect, you must reboot the Scalar 218FC.
To reboot the Scalar 218FC:
1.
Press 3 under the Configuration Program. This displays the following confirmation prompt:
Reboot! Are you sure (Y/N)?
2. To reboot the Scalar 218FC, press Y; to abort, press N.
You are now ready to install the backup software – if it has not already been installed.

Installing the Backup Software

At this point you need to refer to your software installation guide for instructions on installing the backup
and controlling software for the Scalar 218FC onto the host computer.
After you have completed installation of the Scalar 218FC and of the software, you should run any
diagnostic test(s) supplied with the backup software to make sure that your unit is operating correctly.
After your library and host computer are connected, and the application software installed, the library is
ready for use. Just turn on the power switch.
40 Configuring the Fibre Channel Subsystem
0xfee10000, size: 0x00000688.
0xfee10688, size: 0x0004eadc.
0xfee5f170, size: 0x0001b130.