Quantum Scalar 218FC User Manual page 61

Enables/disables the mapping of the storage slots whenever the Scalar Library is powered-up, after the
sliding access panel has been opened and then closed, or if a SCSI bus Reset occurs.
To disable the mapping of slots use the UP or DOWN keys to select "N". Press ENTER to execute
the change.
INIT MAPPING default setting is Y.
Disabling INIT MAPPING by selecting "N" will force INIT
SCAN BARCODES to "N" ( see below).
Init Scan Barcodes
Enables/disables the scanning of the cartridge barcodes whenever the Scalar Library is powered-up, or
after the sliding access panel has been opened and then closed. The application software overrides the
setting of this parameter. If Barcode Scanner configuration is set to No, Initialize Scan Barcodes is
ignored, and the barcode reader is not available to the application software.
To disable the scanning of barcodes use the UP or DOWN keys to select "N". Press ENTER to
execute the change.
INIT SCAN BARCODES default setting is Y.
Enabling INIT SCAN BARCODES by selecting "Y" will force
INIT MAPPING to "Y" ( see above).
Note
Note
Note
Note
Equipment Description 51