Trace Settings Configuration - Quantum Scalar 218FC User Manual

Trace Settings Configuration

Trace Settings Configuration allows you to set the trace level for diagnostics. For performance reasons, trace
settings should all be turned off, except in cases where a problem might be detected by a trace. The default
configuration has all levels set to ON. Pressing 7 on the Configuration Menu results in the following display:
Trace Settings
Build Level: a9802
Level 0 : ON
Level 2 : OFF
Level 4 : OFF
Level 6 : OFF
U) Update Current Operating Trace Levels
X) Return to previous menu
Enter trace level to change >
The Trace capability is provided for diagnostic purposes only.
You should only change the Trace Level settings when
instructed to do so by ADIC Technical Support. Call ADIC
Technical Support at (425) 883-HELP (4357) for additional
information.
To change the trace level:
1.
Enter a trace level number corresponding to the trace level you wish to change. This toggles the current
value between ON and OFF.
2. After all settings have been toggled to the value you desire, you can make them permanent by selecting
U to update the current operating trace level. (Note that Step 4, below, is still necessary, however.
3. Press X to return to the Configuration Menu.
4. Press A to save the your configuration settings.
Save Configuration
Pressing A on the Configuration Menu saves all currently changed values. See the previous examples for the
use of this option.
Restore Last Saved Configuration
Pressing B on the Configuration Menu restores all values from the previously saved configuration.
Reset Configuration to Factory Defaults
Pressing C on the Configuration Menu restores the factory default configuration. The following table
summarizes the default settings:
Setting
Baud Rate
World Wide Name High
Level 1 : OFF
Level 3 : OFF
Level 5 : OFF
Level 7 : OFF
Note
Unique value (set at factory)
Configuring the Fibre Channel Subsystem
Value
9600
31