Ethernet Configuration - Quantum Scalar 218FC User Manual

Invalid SCSI ID. Valid values are 0 - 15.
Press Any Key to Continue...
If the new initiator is in the list of Target SCSI ID(s), you must remove it. See Remove Target SCSI
ID, below. This prevents a SCSI device from being both initiator and target.
4. Press X to return to the Configuration Menu.
5. Press A to save the new SCSI configuration.
Add Target SCSI ID. The target SCSI ID is the ID of the SCSI device receiving a request. You may have
more than one ID as a SCSI target on the Scalar 218FC. To add a Target SCSI ID:
1.
Press 2 while in the SCSI Configuration Menu. The Configuration Menu displays the following prompt:
Add new Target SCSI ID >
2.
Enter a new SCSI Target ID. The Scalar 218FC accepts values between 0 and 15.
The new Target ID is added to the list of Target SCSI IDs under the SCSI Configuration Menu.
If you specify an ID that is already on the list of Target SCSI IDs, no change to the current list is made.
If you specify a number that is out of range, the Configuration Menu displays the following error:
ERROR:
Invalid SCSI ID. Valid values are 0 - 15.
Press Any Key to Continue...
3. Press X to return to the Configuration Menu.
4. Press A to save the new SCSI configuration.
Toggle SCSI Reset Operation. You can set the Scalar 218FC fibre channel subsystem to reset the SCSI
bus on boot. By default, this setting is Yes. To toggle the SCSI reset setting:
1. Press 4 under the SCSI Configuration Menu. The resulting display will reflect the setting change.
Change Discovery Delay Time. You can set the Scalar 218FC fibre channel subsystem to reset the SCSI
bus on boot. By default, this setting is Yes. To toggle the SCSI reset setting:

Ethernet Configuration

To select Ethernet Configuration, press 4 while in the Configuration Menu.
Ethernet Configuration Menu
Build Level: a9802
Current Ethernet Configuration:
Ethernet Physical Address
IP Address
Subnet Mask
1) Change Ethernet Physical Address
2) Change IP Address
3) Change IP Subnet Mask
X) Return to previous menu
The Ethernet Configuration Menu displays:
the current Ethernet Physical Address
: Unique value (set at factory)
: 001.001.001.001 (default value)
: 255.255.255.0 (default value)
Configuring the Fibre Channel Subsystem 27