FastStor 2 Quick Start Guide
Connect the AC power cord
1
FastStor 2 and then to the AC outlet.
Connect a SCSI cable
2
the autoloader and the host system.
Connect a second SCSI (3) cable or
3
a terminator to the open SCSI port.
3
2 2 2
To power up the autoloader, use the
4
eraser end of a pencil or something
similar to press the left side of the
power switch.
4
TM
(1)
to the
On the Operator Panel, press NEXT
5
or PREVIOUS until COMMANDS
displays on the Operator Panel.
Press ENTER.
(2)
between
Press NEXT or PREVIOUS until
6
IMPORT displays. Press ENTER.
1
Press NEXT or PREVIOUS until the
7
desired target slot number is
displayed. Press ENTER.
READY/
CLEAN
MEDIA
ERROR
ACTIVE
DRIVE
ATTENTION
COMMANDS
- - - - - - - -
CANCEL
PREVIOUS
NEXT
ENTER
READY/
CLEAN
MEDIA
ERROR
ACTIVE
DRIVE
ATTENTION
IMPORT TO:
SLOT 1
CANCEL
PREVIOUS
NEXT
ENTER
When the mail slot opens, insert a
8
cartridge into the mail slot.
Repeat until all desired slots are
9
filled.
Power up your host system.
10
Verify your backup software. Note that
11
the default autoloader SCSI ID is 0
and the default drive SCSI ID is 5.
Your FastStor 2 is now ready to
perform a backup or restore operation
via your host system.
6-00516-01 Rev. A
Need help?
Do you have a question about the FastStor 2 and is the answer not in the manual?
Questions and answers