Quantum Scalar 218FC User Manual page 45

scsiConfigResetFlag
fctoSCSIMapTable
fctoSCSIMapEntry
fctoSCSIMapIndex
fctoSCSIbus
fctoSCSItarget
fctoSCSILUN
scsitoFCMappingTable
scsitoFCMapEntry
scsitoFCMapIndexBus
scsitoFCMapIndexSCSIID
scsitoFCMapIndexLUN
scsitoFCMapDestID
scsitoFCMapLUNlo
scsitoFCMapLUNhi
fcNPortPhysTable
fcNPortPhysEntry
fcNPortPhysNPortIndex
FcNPortSpeed
fcNPortMedia
fcNPortTransmitterType
fcNPortDistance
fcNPortLinkState
fcNPortRTTOV
Parameter
fcNPortTopologyModel
Read/Write Toggle SCSI Reset Operation. TRUE indicates that
the SCSI bus will be reset on boot.
A Table containing the Fibre Channel-to-SCSI Map.
An entry in the Fibre Channel-to-SCSI Map Table.
Read Only Index into the Fibre Channel-to-SCSI Map (SCSI
LUN).
Read/Write SCSI bus number.
Read/Write SCSI ID.
Read/Write SCSI LUN.
A Table containing information describing how SCSI
channels are mapped to the Fibre Channel.
An entry in the SCSI-to-FC Mapping Table.
Read Only Index into the SCSI-to-FC Map. SCSI bus number
Read Only Index into the SCSI-to-FC Map. SCSI ID.
Read Only Index into the SCSI-to-FC Map. SCSI LUN.
Read/Write The Fibre Channel Node number.
Read/Write SCSI LUN low bytes.
Read/Write SCSI LUN high bytes.
A Table containing N_Port Physical Characteristics.
An entry in the N_Port Physical Characteristics Table.
Read Only A unique number that identifies an N_Port/NL_Port.
This number ranges from 1 to the value of
fcNodeNumNPorts and its value remains constant for
the identified N_Port/NL_Port until the management
agent of the Node is re-initialized.
Read Only The transmission rate, an FC-0 physical characteristic.
Read Only Type of media, an FC-0 physical characteristic.
Read Only Type of transmitter, an FC-0 physical characteristic.
Read Only The maximum distance, an FC-0 physical
characteristic.
Read Only The state of the FC link. Pending indicates that the
initialization is still pending. Failed indicates that link
initialization has failed. Successful indicates that the
FC Link has initialized successfully.
Read Only Receiver_Transmitter timeout value, used by the
receiver logic to detect Loss of Synchronization.
Read/Write Description
Read Only The topology model on the Link. The N_Port/NL_Port
may be attached to a Fabric, or attached to another
N_Port or to FC-AL (Arbitrated Loop). This value is
only meaningful if the FC Link has initialized
successfully. (i.e. fcNportLinkState = Successful)
Configuring the Fibre Channel Subsystem 35