Configuration - Quantum Scalar 218FC User Manual

Configuration

To configure the Scalar 218FC fibre channel interface, press 1 under the Configuration Program menu. This
displays the Configuration Menu:
Configuration Menu
Build Level: a9802
1) Baud Rate Configuration
2) Fibre Channel Configuration
3) SCSI Configuration
4) Ethernet Configuration
5) Fibre Channel to SCSI Mapping Configuration
6) SCSI to Fibre Channel Mapping Configuration
7) Trace Settings Configuration
8) SNMP Configuration*
A) Save Configuration
B) Restore Last Saved Configuration
C) Reset Configuration to Factory Defaults
X) Return to main menu
Most of the factory default settings within this section
should not have to be modified. The following descriptions
of each menu choice are provided so that you will have a
better understanding of how the fibre channel subsystem
functions.
Menu choice 6) SCSI to Fibre Channel Mapping
Configuration is not supported by your Scalar 218FC.
Call the ADIC Technical Assistance Center at (800) 827-2822
if any default settings do not meet the desired requirements.
Baud Rate Configuration
The baud rate is the rate of speed used by the Scalar 218FC Fibre Channel serial port to communicate with
another serial device. To configure the baud rate, press 1. This displays the following menu of choices:
Baud Rate Configuration Menu
Build Level: a9802
1) * 9600 2)
3) 38400 4)
5) 115200
22 Configuring the Fibre Channel Subsystem
Notes
19200
57600