Quantum Scalar 218FC User Manual page 44

ADIC Private MIB
The following chart lists all attributes that can be specified using the ADIC private SNMP MIB. Included
with each attribute are the attribute's read/write property and a brief description of the meaning of values
read or written.
Parameter
fcConfigNodeName
fcConfigNodeNumNPorts
fcConfigEnableReset
fcConfigUseHardAddress
fcConfigSourceID
fcConfigSCSIMode
fcConfigTraceMask
fcConfigReset
fcConfigCommit
miSerialBaudRate
miMACAddress
miethernetIPAddr
miethernetIPNetmask
miCommunitySet
miCommunityGet
scsiConfigTable
scsiConfigEntry
scsiConfigIndex
scsiConfigInitID
scsiConfigTargetIDAdd
Parameter
scsiConfigTargetIDRemove
34 Configuring the Fibre Channel Subsystem
Read/Write Description
Read/Write Worldwide name of a collection of N_Ports that
comprise a Node.
Read Only Number of N_Ports that comprise the named Node.
Read/Write Toggle for software reset. True indicates that resetting
the product via SNMP is allowed. NOTE: each time
the product is initialized this object is set to FALSE
(i.e. it is not sticky).
Read/Write Toggle for address configuration. True indicates that
configuration of the source ID is allowed. False
indicates that the source ID may not be changed.
Read/Write 3 byte Source address. For arbitrated loop, this will be
the Hard Assigned AL_PA (preceded by 20 bytes).
Read/Write Fibre Channel-to-SCSI mapping mode.
Read/Write Trace Level.
Read/Write Reset the product. Setting this object to TRUE will re-
start all the software (similar to powering the product
off, then on). The reset will only take place if
fcConfigResetEnable is also TRUE. NOTE: resetting
the product will disconnect all current Fibre Channel
connections.
Read/Write Commit the configuration values to the flash memory.
Read/Write The baud rate for the serial interface.
Read/Write Physical address (MAC address).
Read/Write The IP address for this device.
Read/Write Ethernet Net Mask.
Read/Write SNMP Community name for Sets. Not supported.
Read/Write SNMP Community name for Gets. Not supported.
Read/Write A Table containing SCSI Configuration parameters.
Read/Write An entry in the SCSI Configuration Table.
Read Only Index into the SCSI Configuration Table.
Read/Write Initiator SCSI ID.
Read/Write Set this SCSI target ID.
Read/Write Description
Read/Write Remove this SCSI target ID. The SCSI ID you specify
will no longer be a target.