Quantum Scalar 218FC User Manual page 100

In the above display, 0 = closed, cartridge not present, or cartridge installed correctly; 1 = open,
cartridge present, or cartridge incorrectly installed. The HM sensor is the sensor that the Media Picker
homes to when calibrating. The DOOR sensor is the sensor that senses the state of the sliding access
panel on the desktop Scalar, and the position of the rack-mounted Scalar (0 = Scalar pushed into rack, 1
= Scalar pulled out from rack). The SLOTS sensor display is organized as slots 13-18 on the second line
(SLOT 18 is the Mailbox slot), and slots 1-12 on the third line. The 12 characters at the beginning of the
fourth line represent the state of the state of the cartridges installed in slots 1-12. If the character is a 0,
the cartridge is installed correctly in the slot; if a 1, the cartridge is not correctly installed (i.e., may be
upside-down).
This function is usually used for diagnostics only by a trained technician.
Run Demo
The Run Demo function causes the Scalar Library to execute a demo program included in its
firmware. The demo assumes that cartridge storage slots 1 through 12 are occupied, that slots 13
through 17 are empty, and that neither drive has a cartridge loaded. The program picks cartridges from
the occupied slots and places them in empty slots and also the drives. The Demo continues to run until
the ESC key is pressed. Pressing ESC a second time causes the Scalar 218FC to exit the program.
Press ENTER to activate.
90 Diagnostics Menu