Fibre Channel-To-Scsi Mapping Configuration - Quantum Scalar 218FC User Manual

Fibre Channel-to-SCSI Mapping Configuration

For a discussion of Fibre Channel-to-SCSI mapping, see Appendix A. To configure Fibre Channel-to-SCSI
mapping, select item 5 from the Configuration Menu. This presents the following display:
Fibre Channel to SCSI Configuration Menu
Build Level: a9802
Current Fibre Channel to SCSI Mapping Mode is Auto-assigned
1) Display Attached SCSI Devices, LUN Priority
2) Display Attached SCSI Devices, Target ID Priority
3) Display Attached SCSI Devices, Bus Number Priority
4) Change the Fibre Channel to SCSI Mapping Mode
X) Return to Previous Menu
LUN Priority Display. To view LUN priorities of attached SCSI devices:
1.
Press 1 while in the Fibre Channel-to-SCSI Configuration Menu.
The Configuration Menu displays a screen similar to the following:
Querying SCSI devices, please be patient ...
Currently Attached Devices
Build Level: userLevel
BUS TGT LUN DEVICE DESCRIPTION
0 1 0
0 2 0
0 3 0
X to return, <enter> for more >
Target ID Priority Display. To display the target ID priorities of SCSI devices, select 2. This results in a
display similar to the one shown above.
Bus Priority. Item 3 has no significance on the Scalar 218FC, since it only has one SCSI bus. Selecting this
choice results in the following error:
ERROR:
There is only one bus on this device
Press Any Key to Continue...
Fibre Channel-to-SCSI Mapping Mode. This allows you to select the way in which Fibre Channel
addresses are mapped to SCSI addresses.
Pressing 4 on the Fibre Channel-to-SCSI Mapping Mode Configuration Menu displays the following menu of
selections:
Fibre Channel to SCSI Mapping Mode Configuration Menu
Build Level: a9802
Current Fibre Channel to SCSI Mapping Mode is Auto-assigned
1) Set to SCC
2) Set to Indexed
3) Set to Auto-assigned, LUN priority
Scalar 448
Quantum DLT 7000
Quantum DLT 7000
Configuring the Fibre Channel Subsystem 29