Trace Dumps - Quantum Scalar 218FC User Manual

FcNPSIndex
FcNPSInDeviceDataFrames
FcNPSOutDeviceDataFrames
FcNPSInLinkDataFrames
FcNPSOutLinkDataFrames
FcNPSInLCRFrames
FcNPSOutLCRFrames
FcNPSInPBSYFrames
FcNPSOutPBSYFrames
FcNPSInPRJTFrames
FcNPSOutPRJTFrames
FcNPSAborts
FcNPSLaserFaults
FcNPSLOS
FcNPSBadRXChar
FcNPSClearRegisters

Trace Dumps

The Trace Dump selection on the Configuration Program menu allows you to perform traces of Scalar 218FC
activity for diagnostic purposes. The trace levels defined in Trace Settings Configuration (see above)
determine the level of detail displayed. You can perform a trace dump of either the current or previous Scalar
218FC boot cycle (the period of operation between power on or reboot until either the trace dump is
performed or the system is powered off). If you encounter problems with your Scalar 218FC, you may be
asked by an ADIC Support Engineer to perform the following operation. To perform a Trace Dump:
1. Press 2 on the Configuration Program main menu. This displays the Trace Dump menu.
Trace Dump Menu
Build Level: a9802
1) Dump trace for the current boot cycle
2) Dump trace from the previous boot cycle
X) Return to previous menu
Read Only A unique number that identifies an N_Port. This
number ranges from 1 to the value of
fcNodeNumNPorts and its value remains constant for
the identified N_Port until the management agent of
the Node is re-initialized.
Read Only The number of Device Data frames received by this
N_Port/NL_Port.
Read Only The number of Device Data frames transmitted by this
N_Port/NL_Port.
Read Only The number of Link Data frames received by this
N_Port/NL_Port.
Read Only The number of Link Data frames transmitted by this
N_Port/NL_Port.
Read Only Counter not implemented.
Read Only Counter not implemented.
Read Only The number of P_BSY frames received by this
N_Port/NL_Port.
Read Only The number of P_BSY frames transmitted by this
N_Port/NL_Port.
Read Only The number of P_RJT frames received by this
N_Port/NL_Port.
Read Only The number of P_RJT frames transmitted by this
N_Port.
Read Only Number of Aborts.
Read Only Number of laser faults.
Read Only Number of seconds of Loss of Signal.
Read Only Number of bad characters received.
Read/Write Clear (zero) all N-Port Statistics Registers.
Configuring the Fibre Channel Subsystem 37