Primarycallchoice - Polycom ViewStation EX Api Manual

primarycallchoice

© Polycom, Inc. 2003
ViewStation EX, ViewStation FX, and VS4000 API Guide
This command sets the presets or goes to presets for the near or far
camera source. It can also register or unregister the Telnet or
RS-232 session to give notification when the user sets or goes to
presets. You can set and store up to ten preset camera positions.
These ten camera presets can be distributed across the far camera
and up to four near-site cameras.
near set Sets a near camera preset number. Requires a
parameter from {0..9}.
near go Selects a near camera preset number. Requires a
parameter from {0..9}.
far set Sets a far camera preset number. Requires a parameter
from {0..9}.
far go Selects a far camera preset number. Requires a
parameter from {0..9}.
register Registers the system to give notification when the user
sets or goes to presets.
unregister Disables register mode.
0..9 Range of available preset numbers.
Example
preset near set 2
The current location/position of the near end camera is saved in near
slot 2.
primarycallchoice <isdn|ip|manual|get>
Description
This command sets the Global Address Book (GAB) Primary Call
Type Choice. It sets which call type the ViewStation system will try
first when dialing a site (which can be reached via H.320 and H.323)
from the Address Book. It is automatically reset to manual if the
setting matches that of the Secondary Call Type Choice (see the
command secondarycallchoice on page 125).
isdn Selects ISDN as the Primary Call Type Choice.
117