ITech IT8700P+ Series User Manual page 76

Adc=0.0000A
Wdc=0.00W
4 4
Shift
3. Press +
▼ ▼
key to select <Trigger Source>, such as select <Manual>on the
front panel, press
Manual
External
Hold
Bus
Timer
On/Off On/Off
4. Press to close the load's input.
Shift Shift
5. Press +5，press
key to confirm, press
key to confirm.
Function Mode
Recall OPP
Edit OPP
6. Set Von voltage value, press
Von Point Set
= 0.000V
7. Set Von voltage delay time, press
Von Delay Set
= 0.000000S
8. Select working current range, press
High Range
Middle Range
Low Range
9. Set initial current value, press
Start Current
Set= 0.0000A
10. Set step current value, press
Step Current
Set= 0.0000A
11. Set step delay time, press
Step Delay Set
= 0.000000S
12. Set cutoff current value, press
End Current
Set= 0.0000A
13. Set OPP value, press
OPP Voltage
Set= 0.000V
14. Set overcurrent range (maximum value), press
Max Current
Set= 0.0000A
15. Set overcurrent range (minimum value), press
Min Current
Set= 0.0000A
16. Save OPP test documents, press
Save OPP File
= 1（1-5）
Copyright © Itech Electronic Co., Ltd.
(System) keys to enter system menu function, press
Enter
key to confirm.
▼ ▼
key to select <OPP Test >, press
▼ ▼
key to select List<Edit OPP>, press
Enter
to confirm.
Enter
Enter
Enter
to confirm.
Enter
to confirm.
Enter
to confirm.
Enter
to confirm.
Enter
to confirm.
Enter
Operations introduction
to confirm.
to confirm.
Enter
to confirm.
Enter
to confirm.
to confirm.
Enter
Enter
67