ITech IT8700P+ Series User Manual page 70

13. Whether you need to link to the next file to be tested, if you need to link to
group 2, press number key 2, 0 stands for not linking to other files. Press
Program Chain
NO: 0
14. Save the edited files in Eeprom, you can save up to 10 groups of files, e.g
please press numeric key
press
Save Program
NO: 1
15. Press
Edit Auto Test Step Parameter
1. Select the channel you want to edit, then edit every group's every step, we
select channel 3 and channel 5 in above, press
switch channels, after selecting channel 3.
2. Press
﹥MODE =CC
Range=HIGH
Iset =1.00 A
You can edit every step's mode, ﹥MODE =CC, press
3.
the menu, press
﹥Const Current, press
for example, RANGE=HIGH, press
﹥Const Current
Const Voltage
Const Resis.
4. Press
enter the menu, set the working current, for example, set 1A, press
numeric key
Const Current
Set = 1.000A
5. Press
high limit of testing voltage, press
In this example, the first step is 5.8V, press
press
Voltage Upper
Limit = 5.800V
6. Press
low limit of testing voltage, press
Enter Enter
key to confirm.
Enter Enter
to confirm.
Esc Esc
key twice to exit.
NOTE
In the following editing procedures, "Y indicates selected status. To cancel selected status,
press numeric key of corresponding step again. The above steps only set entire
framework of auto tests. Additional setting is required for specific parameters in each step.
This design will facilitate modification of parameters in a single step.
Setup Setup
key
▼ ▼
▼ ▼
key, move the cursor to ﹥Iset =1.00 A, press
1 1
, then press
▼ ▼
to move the cursor to Vmax=82.000V, you need to set the
Enter Enter
key to confirm.
▼ ▼
key to move the cursor to Vmin=0.000V, you need to set the
Copyright © Itech Electronic Co., Ltd.
1 1
to save the edited file in group 1, and then
▲ ▲
、
key to select mode, for example, select
Enter Enter
to confirm. Press
Enter Enter
to enter the menu.
Enter Enter
to confirm.
Enter Enter
to enter the menu.
Enter Enter
key to enter the menu.
Operations introduction
▼ ▼ ▲ ▲
、
keys to
Enter Enter
key to enter
▼ ▼
to select range,
Enter Enter
. .
5 5 8 8
、 、
keys, then
to
61