Table of Contents
Advertisement
1.3 Module installation
Two load modules can be installed into IT8701P mainframe, and four load
modules can be installed into IT8702/IT8702P mainframe. If the modules
installed all have double channels, the load will have eight channels at
maximum. Load modules can be installed at any sequence into the mainframe.
IT8703/IT8703P extended frame can also contain four load modules. The
installation steps of extended frame are the same as single mainframe, which
just need screwdriver.
Installation steps:
1.
Turn off the power switch and disconnect the 110V/220V power cord.
2.
Remove the front cover panel on machine frame. First remove the pale
gray sticker on the cover panel, and then loosen the screw at the sticker.
3.
Remove the rear cover panel on machine frame. Remove the top cover
panel of the machine frame first, and then remove the cover panel. Then
install the top cover panel.
Copyright © Itech Electronic Co., Ltd.
Inspection and Installation
11
Advertisement
Table of Contents
