ITech IT8700P+ Series User Manual page 40

Slow
Med〈Default〉
Fast
V AutoRange Auto switching voltage range
On〈Default〉
Off
PROTECT Load protecting function
Max Power Set
Alimit State
Alimit Point
Alimit Delay
Plimit Point
Plimit Delay
On Timer State
On Timer Set
Exit
LIST
Function Mode
Recall List
Edit List
Exit
CR-LED Simulate the LED light to test LED power drive（in CR mode）
On
Off 〈Default〉
Ext. Ctr1 Set External analog control function
On
Off 〈Default〉
Rem Sense Set Remote measuring
On
Off 〈Default〉
About Module production information
IT87XX
VER: X.XX
SN:
XXXXXXXXXXXXX
EXIT

Configure menu list of IT8731P+/IT8732P+/IT8733P+/IT8732BP+/
IT8733BP+/IT8722P+/IT8722BP+/IT8723P+ module:
MENU
Sync On Set Setup Synchronization On / Off function
On〈Default〉
Off
Von
Von Point
Von Latch
Exit
Measure Rate Filter the input voltage of the instrument to reduce interference.
Slow
The filtering speed is low speed.
The filtering speed is medium speed.
The filtering speed is fast speed.
Enable this function
Disable this function
Setup hardware power protecting
Setup software current protecting state
On
Off〈Default〉
Setup software current protecting value
Setup software current protecting delay
Setup software power protecting value
Setup software power protecting delay
Setup Load ON timer state
Setup Load ON timer time
Select Mode
Fixed
List
Recall list operation file
Edit list operation file
Enable the function（in CR mode, press "setup" to set Vd
level）
Disable this function
Turn on external analog control function
Turn off external analog control function
Enable remote sense function
Disable remote sense function
Channel production model
Channel software version
Channel production serial number
Turn on synchronization function
Turn off synchronization function
Set the load's von point
Von point latch state, On / Off
The filtering speed is low speed.
Copyright © Itech Electronic Co., Ltd.
Panel function introduction
Put on
Put off
Choose fixed operation mode
Choose list operation mode
31