ITech IT8700P+ Series User Manual page 36

Chan Chan
Switch channel via
main frame controls all modules. Every module has its own
channel number, select the channel to be edited on the main
frame panel first, then start to edit, e.g. if you want to edit the
5th channel, press
installed channels, press number key 5 directly to switch to 5
channel, now the channel can be edited .
Save Save Save Save
edit its parameters, set work mode, voltage, current, Slope,
the dynamic parameters and so on. Press
save, up to 101 groups of parameters can be saved. All the
parameters are saved in the Non-volatile memory, support
power-off saving.
Re call Re call Re call Re call
fast recall the saved 101goups parameters. All the used
parameters only need to be edited and saved for one time and
they will be always saved in the EPROM. You just need to
recall them if necessary. It brings great convenience to the
users, and save time.
Setup Setup Setup Setup
this key, you can achieve A/B transient mode, CC/CV/CR
mode and so on, this menu has been introduced in detail in
the menu list.
On/Off On/Off On/Off On/Off
when you enabled the synchronization function in the menu of
a channel, the key can correspondly control the on/off state of
the channel.
Trig Trig Trig Trig
or the transient output, you should select the triggering
source, this load have 5 kinds triggering mode, panel
triggering is only one of them. It will be introduced in detail in
the front panel triggering operation chapter.
Start Start Start Start
edited automatic test file, press up and down to select
press
Pause Pause Pause Pause
when running a automatic test, at this time the VFD will
display pausing at a step, press
the file continuously.
4. Comprehensive key+
4 4
Shift Shift
keys； +
introduced in detail in the menu list; if the load is in remote sense mode,
7 7
Shift
press +
module's panel keyboard and knob, repress them can unlock it;
key, can be used to exit any working state;
▲ ▲
key is used to move up, select the menu;
move down, select the menu;
a comprehensive key.
Copyright © Itech Electronic Co., Ltd.
Chan Chan
key：IT 8700 is a muti-load, one
Chan Chan
key first, the VFD will show all the
key is used to save data：After selecting the channel,
key is used to recall data:
key is used to enter the specific channel's menu：press
key is used to control module's input state on/off:
key is used to trigger: when you edit the auto test file
key is used to start automatic test：after recalling the
Start Start
key to start automatic test.
key is used to pause：only press
0 0 9 9
～
number keys：
5 5 6 6
/ / key will respectively enter 3 menu, it has been
key can switch to local mode;
Enter Enter
key is used to confirm;
Panel function introduction
Save Save
key to
Re call Re call
key can be used to
Pause Pause
key to pause
Pause Pause
key once again to test
0 0 9 9
～
are number input
8 8
Shift Shift
+ key can lock
Esc Esc
. .
key means a point;
▼ ▼
key is used to
Shift Shift
Start Start
,
exit
key is
27