A/B Transient Operations - ITech IT8700P+ Series User Manual

4.4.4 A/B transient operations

The following will show you how to set operation mode on front panel. Take CC
mode as an example:
1. Power on the electronic load
2. Press
channel 1
CH01 CC OFF
Vdc=0.0000V
Adc=0.0000A
Wdc=0.00W
3. Press
enter the mode selection menu <Mode>, press
mode CC/CV/CR/CW，such as CC，press
CH01
Mode=CC
RANGE=HIGH
Iset=9.000A
4. Press
enter the mode selection menu <Mode>, press
as <low range>, press
CH01
High Range
Low Range
5. Press
1A/uS，press
CH01
Rise Speed Set
= 1.00A/Us
6. Press
slope to be 2A/uS. Press
CH01
Fall Speed Set
7. Press
press
Transition
Level = 10.00A
8. Press
Fig 4-8 toggled mode current waveform
▲ ▲ ▼ ▼
、
Setup Setup
key to enter the channel setup menu, press
▼ ▼
key to enter range setting <Range>, press
▼ ▼
key to enter the rise slope <∫>, such as set the current to be
Enter
key to confirm
▼ ▼
key to enter the fall slope setting <∫>, such as set the rise
= 2.00A/Us
▼ ▼
key to enter A LEVEL setting <TRANa>，such as 10.00A,
Enter
key to confirm
A
▼ ▼
key to enter A level width setting <Ta>，such as 0.003S，
Copyright © Itech Electronic Co., Ltd.
keys to select the channel to be edited, such as
Enter
Enter
key to confirm.
Enter
key to confirm
Operations introduction
Enter
key to
▼ ▼
key to select the
key to confirm
Enter
key to
▼ ▼
key to select, such
50