Environmental Conditions; Regulatory Markings - ITech IT8700P+ Series User Manual

Environmental Conditions

The instrument is designed for indoor use and an area with low condensation.
The table below shows the general environmental requirements for the
instrument. The speed of fan will change intelligently by the temperature of
radiator. When the temperature is up to 40°C, the fan will be on and adjust
intelligently when temperature changes.
Environmental Conditions
Operating temperature
Operating humidity
Storage temperature
Altitude
Pollution degree
Installation category

Regulatory Markings

Note
To make accurate measurements, allow the instrument to warm up for 30 min before
operation.
The CE tag shows that the product complies with the
provisions of all relevant European laws (if the year is
shown, it indicates that the year when the design is
approved).
The UKCA tag shows that the product complies with the
provisions of all relevant United Kingdom laws (if the year
is shown, it indicates that the year when the design is
approved).
This instrument complies with the WEEE directive
(2002/96/EC) tag requirements. This attached product
tag shows that the electrical/electronic product cannot be
discarded in household waste.
This symbol indicates that no danger will happen or
toxic substances will not leak or cause damage in
normal use within the specified period. The service life
of the product is 10 years. The product can be used
safely within the environmental protection period;
otherwise, the product should be put into the recycling
system.
Copyright © Itech Electronic Co., Ltd.
IT8700 User Manual
Requirements
0°C to 40°C
20%-80% (non-condensation)
-20°C to 70 °C
Operating up to 2,000 meters
Pollution degree 2
II
iii