ITech IT8700P+ Series User Manual page 71

In this example, the first step is 0.15V, press
then press
press
Voltage Lower
Limit = 0.150V
7. Press
step of channel 5, repeat 1）～6）steps, after editing the menu, press
key to exit.
8. Then save the edited first step of channel 3 and channel 5, press
and numeric key 1 to save step 1 in the same way, you can edit the rest 3
steps of channel 3 and channel 5. After saving, press
Save Gropu
1
Program
Save Group
Program
Save Group
Program 10 Sequence
Save Group
Recall testing files and Run testing files
The following way can make you fast recall the edited testing files from
EEPROM after re-powering.
1. Press
Run Program
Recall Prog
Edit Program
Exit
2. Press
3. Press
4. Press
Enter Enter
key to confirm. After editing the first step of channel 3,
Esc Esc
key to exit.
▼ ▼ ▲ ▲
keys to select channel 5, in order to select the first
NOTE
Settings at each step should be independently saved. Saving positions of step
parameters are related to save group and step number of auto test files. If the auto test
file is saved in group 1, the saving position of step parameter is consistent with the step
number; if the auto test file is saved in group 2, the saving position is 1+ step number, for
example, steps 1, 2 and 3 are saved in 11, 12 and 13 respectively; if the auto test file is
saved in group 3, the saving position is 2+ step number, for example, steps 1, 2 and 3 are
saved in 21, 22 and 23 respectively, and so on. Refer to the following table for saving
position.
Correspondence Table of Auto test files and step parameter saving.
1 Sequence 1
1
2 Sequence 1
11
:
:
1
91
6 6
Shift Shift
+ to enter the menu
▼ ▼
to move to <Recall Prog> to recall the saved testing files.
▼ ▼
to move to <Run Program>.
Start Start
key to start automatic testing, if you need to pause, press
Pause Pause
key, then press
Pause Pause
key to continue the test until the test is finished.
Copyright © Itech Electronic Co., Ltd.
0 0
2 3 4 5
2 3 4 5
2 3 4 5
12 13 14 15
2 3 4 5
92 93 94 95
▼ ▼
key to continue test by one step. press
Operations introduction
. .
1 1 5 5
、 、 、
keys,
Esc Esc
Save
Enter Enter
to confirm.
6 7 8 9 10
6 7 8 9 10
6 7 8 9 10
16 17 18 19 20
6 7 8 9 10
96 97 98 99 100
62