Transient Operation - ITech IT8700P+ Series User Manual

>High Range
Low Range
5. Press
to be 1.25A，press
CH01
Const Current
Set= 1.25A
Enter
6. Press
Press numeric key to set the maximum voltage value.
CH01
Voltage Upper
Limit=82.000V
Enter
7. Press
Press numeric key to set the minimum voltage value.
CH01
Voltage Lower
Limit=0.000V
Enter
8. Press
to be 1A/uS. Press
CH01
Rise Speed Set
= 1.00A/uS
Enter
9. Press
to be 2A/uS. Press
CH01
Fall Speed Set
= 2.00A/uS
Enter
10. Press
11. Press
CH1 CC ON
Vdc=0.0000V
Adc=0.0000A
Wdc=0.00W

4.4 Transient operation

Transient operation enables the module to periodically switch between two load
levels, as might be required for testing power supplies. Transient operation can
be turned on and off at the front panel (
on the operation, you should set the parameters associated with transient
operation (
and transient testing modes.
The transient testing modes have 3 kinds: continuous, pulsed, or toggled.

Continuous: Generates a respective pulse stream the toggles between two
load levels

Pulse: Generates a load change that returns to its original state after some
▼ ▼
key to enter the current setting <Iset>, such as set the current
Enter
key to confirm. If any error, press Esc to back.
Esc
▼ ▼
key to enter the maximum voltage value setting, press
Esc
▼ ▼
key to enter the minimum voltage value setting, press
Esc
▼ ▼
key to enter the rise slope setting, such as set the rise slope
Enter
key to confirm
Esc
▼ ▼
key to enter the fall slope setting, such as set the fall slope
Enter
key to confirm
Esc
Esc Esc
key to exit
On/Off On/Off
to open the load's input
Setup Setup
). The parameters include: A level, A width, B level, B width,
Copyright © Itech Electronic Co., Ltd.
Operations introduction
Trig Trig
Tran Tran
and keys), before you turn
Enter
.
Enter
.
48