ITech IT8700P+ Series User Manual page 74

existing current value is within target scope again. If yes, PASS the test.
Edit OCP testing files
1. Power on the electronic load.
2. Press
channel 1.
CH01 CC OFF
Vdc=0.0000V
Adc=0.0000A
Wdc=0.00W
3. Press
front panel, press
Manual
External
Hold
Bus
Timer
4. Press
5. Press
key to confirm, press
key to confirm.
Function Mode
Recall OCP
Edit OCP
6. Set Von voltage value, press
Von Point Set
=
7. Set Von voltage delay time, press
Von Delay Set
=
8. Select working current range, press
High Range
Middle Range
Low Range
9. Set initial current value, press
Start Current
Set=
10. Set step current value, press
Step Current
Set=
11. Set step delay time, press
Step Delay Set
=
12. Set cutoff current value, press
End Current
Set=
13. Set OCP value, press
OCP Voltage
Set=
14. Set overcurrent range (maximum value), press
Max Current
Set=
▲ ▲ ▼ ▼
、
keys to select the channel to be edited, such as
4 4
Shift
+ (System) keys to enter system menu function, press
▼ ▼
key to select <Trigger Source>, such as select <Manual>on the
Enter
On/Off On/Off
to close the load's input.
Shift Shift
+5，press
0.000V
0.000000S
0.0000A
0.0000A
0.000000S
0.0000A
Enter
0.000V
0.0000A
Copyright © Itech Electronic Co., Ltd.
key to confirm.
▼ ▼
key to select <OCP Test >, press
▼ ▼
key to select List<Edit OCP>, press
Enter
to confirm.
Enter
to confirm.
Enter
to confirm.
Enter
to confirm.
Enter
to confirm.
Enter
to confirm.
Enter
to confirm.
to confirm.
Operations introduction
Enter
Enter
Enter
to confirm.
65