Omron E5GC User Manual page 93

E5EC/E5AC
Option number: 011, 012, 013, or 014
E5EC-B
Option number: 011
Output type
Current output
Linear voltage output
Note: The E5CC-U, E5DC, and E5GC do not have a transfer output. However, if the control output is a linear
current output, the control output can be used as a simple transfer output. For details on the operating
procedure, refer to 5-13 Using the Transfer Output for the Process Value, Set Point, or other Data.
* The E5CC-U must be manufactured in May 2014 or later (version 2.2 or higher) and the E5DC must
be manufactured in July 2014 or later (version 2.2 or higher).
Remote SP Input
Models with an option number of 007 or 011 to 014 have a remote SP input.
Input type
Current input
Linear voltage input
Note: The E5CC-U, E5CC-B, E5DC, and E5GC do not have a remote SP input.
The remote SP input circuit is not electrically isolated from the internal circuits. Therefore, when using a
grounded sensor input, do not connect the remote SP input terminals to ground. (If the remote SP input
terminals are connected to ground, errors will occur in the measured temperature as a result of leakage
current.)
Potentiometer Input
You can use this input for a Position-proportional Model. The maximum opening can be measured to between
100 and 10KΩ.
Note: The E5CC, E5CC-U, E5CC-B, E5EC-B, E5DC, and E5GC do not have a potentiometer input.
E5@C Digital Temperature Controllers User's Manual (H174)
v
+
+ +
32 31
L L
V
33
33
− −
Current output
Linear voltage output
v
+
+ +
43 42
L L
V
44
44
− −
Current output
Linear voltage output
4 to 20 mA DC, Load: 500 Ω max., Resolution: 10,000
1 to 5 VDC, Load: 1 kΩ min., Resolution: 10,000
4 to 20 or 0 to 20 mA DC with input impedance of 150 Ω max.
1 to 5, 0 to 5, or 0 to 10 VDC with input impedance of 1 MΩ min.
Specification
Specification
2 Preparations
2
2 - 57