Omron E5GC User Manual page 102

2 Preparations
E5DC
Setup Tool Port and Connecting Cable
The locations of the Setup Tool ports on the E5DC and the required cables are shown below.
There are Setup Tool ports on both the bottom panel and front panel of the Digital Controller.
Main Unit Bottom Panel
Bottom-panel
Setup
Tool port
* This Cable is required only to connect to the front-panel Setup Tool port.
Connection Procedure
• Bottom-panel Port
1
Connect the serial connector
to the Setup Tool port on the
bottom panel of the Digital
Controller.
2 - 66
Setup Tool port
Main Unit Front Panel
Front-panel
Setup Tool port
Connecting cables
E58-CIFQ2
USB-Serial Conversion Cable
E5@C Digital Temperature Controllers User's Manual (H174)
E58-CIFQ2-E
Conversion Cable*