Omron E5GC User Manual page 359

Calibrating a Voltage Input
In this example, calibration is shown for a Digital Controller with an analog input, with a voltage input
set as the input type.
adj
30
• Input type 27 or
28:
1V 5
c7c3
• Input type 29:
2V10
b104
• Input type 30:
t 54
b9a5
E5@C Digital Temperature Controllers User's Manual (H174)
1. Connect the power supply.
2. Connect an STV and DMM to the voltage input terminals, as shown in the following
diagram.
E5CC, E5CC-U, E5EC, E5AC, E5DC, or E5GC
C
Input power supply
D
−
STV
DMM
+
The terminal numbers are as follows:
• Input Terminals (Negative and
Positive)
E5CC: 5 and 6
E5CC-U: 2 and 1
E5EC/E5AC: 23 and 24
E5DC: 13 and 14
E5GC: 11 and 12
• Input Power Supply (C/D)
E5CC: 11 and 12
E5CC-U: 10 and 11
E5EC/E5AC: 1 and 2
E5DC: 1 and 2
E5GC: 1 and 2
3. Turn the power ON.
4. Move to the Calibration Level.
This starts the 30-minute aging timer. This timer provides an approximate timer for aging.
After 30 minutes have elapsed, the No. 2 display changes to 0. You can advance to the next
step in this procedure even if 0 is not displayed.
5. When the M Key is pressed, the status changes as shown to the left.
The No. 2 display at this time shows the currently entered count value in hexadecimal. Set
the STV as follows:
• Input type 27 or 28:
• Input type 29:
• Input type 30:
Allow the count value on the No. 2 display to fully stabilize, then press the D Key to
temporarily register the calibration settings.
If this count value is outside of the specified range, the No. 2 display will flash and the count
value will not be temporarily registered.
Input power supply
* Common terminals are indicated with asterisks (*).
The terminal numbers are as follows:
• Input Terminals (Negative and Positive)
E5CC-B: 7 and 8
E5EC-B: 31 and 32
• Input Power Supply (C or C', and D or D')
E5CC-B: 13 or 14, and 15 or 16
E5EC-B: 1 or 2, and 3 or 4
5 V
10 V
54 mV
7 User Calibration
@
E5 C-B
C
*
C'
D
*
D'
−
STV
DMM
+
7
7 - 11