GE LOGIQ P9 Service Manual page 437

GEDRAFT
D 5604324, R
IRECTION EVISION
3) Remove EEPROM from replacement MCB board if present.
4) Verify direction of the EEPROM Slot by aligning EEPROM "notch" mark to that of MCB board. print
mark.
NOTE: Inserting EEPROM in wrong direction will result in permanent damage to EEPROM or to MCB board.
Proceed with caution.
5) Verify tips of all 8 pins are aligned with socket.
6) Gently push down EEPROM to its position.
8-17-12 Separating MCB assy from Brackets and COM Express
1) Remove 7 screws around MCB assy. Refer to following figure.
11 DRAFT (J
Alignment marks
U44 Socket
(print mark)
Figure 8-124 Aligning EEPROM
Figure 8-125 Screw points around MCB assy
Chapter 8 - Replacement Procedures
24, 2019)
ANUARY
LOGIQ P9/P7
S M
ERVICE ANUAL
8-111