GE LOGIQ P9 Service Manual page 434

GERAFT
D 5604324, R
IRECTION EVISION
8-17-9 Removal Procedure - Separating DCWD Board(Option) from MPI
Philips screw-driver required to add this part.
1) Remove 3 screws on MPI assy.
2) Carefully separate DCWD board from MPI assy not to damage the DCWD connector. Refer to
following figure.
8-108
11 DRAFT (J
Figure 8-118 DCWD Board screw points
Figure 8-119 Position of DCWD board connector
Section 8-17 - Replacement around Nest Box
24, 2019)
ANUARY
LOGIQ P9/P7
S M
ERVICE ANUAL