GE LOGIQ P9 Service Manual page 334

GERAFT
D 5604324, R
IRECTION EVISION
• The Hard Disk Drive (HDD) on LOGIQ P7/P9 is divided into four visible (R1.x.x.) or
five (R2.x.x or later) visible partitions.
Table 8-2
Drive Letter
C:
D:
E:
Z:
Table 8-3
Drive Letter
C:
D:
E:
V:
Z:
NOTE: Before loading the Base System Software, you must perform the following steps:
• Contact the customer to allow enough lead time to back up the system.
• Be sure no images are in the clipboard or opened exams.
• Review troubleshooting section to collect information for future analysis if you are troubleshooting
loss of image or patient data.
• Disconnect the system from the network and remove all transducers from the system.
• Be sure all USB devices (printers only) are connected and turned on (except for USB Flash
devices). If a printer is plugged in at this time, it is automatically installed.
• Save all Service Presets if you are connected to InSite to restore remote connectivity after
something is completed.
• Save all User Presets.
NOTE: After a full or partial system software load, be sure to check the system date, time and time zone are
set correctly.
8-8
11 DRAFT (J
Use of the Partitions (R1.x.x)
Label
SYSTEM
USER
ARCHIVE
REPOSIT
Use of the Partitions (R2.x.x or later)
Label
SYSTEM
USER
ARCHIVE
DVR
REPOSIT
Section 8-3 - System Software - Installation/Upgrade Procedure
24, 2019)
ANUARY
LOGIQ P9/P7
S M
ERVICE ANUAL